Setting up the Linksys E9450 as a Non-Mesh System
This article will show you how to set up your Linksys E9450 WiFi 6 Router to Non-Mesh System. In this system, you will not be able to add child nodes. If you have only one Linksys E9450 and would rather not use a mesh system, follow the steps below.
This article is for Linksys E9450-AH, Linksys E9450-CN, Linksys E9450-JP, and Linksys E9450-KR.
This article is for Linksys E9450-AH, Linksys E9450-CN, Linksys E9450-JP, and Linksys E9450-KR.
1. Set up your router using the browser-based setup wizard. If your router is already set up, go to Step 2.
2. After your router is set up, launch a web browser, enter “192.168.79.1” or “linksysxxxxx” where xxxxx is the last five characters of the serial number in the Address bar, and hit [ENTER].
3. Enter "admin" as the username and enter your password, then click Apply. The default username and password is admin.
2. After your router is set up, launch a web browser, enter “192.168.79.1” or “linksysxxxxx” where xxxxx is the last five characters of the serial number in the Address bar, and hit [ENTER].
3. Enter "admin" as the username and enter your password, then click Apply. The default username and password is admin.
4. Go to General > Mesh Setup and select Non-Mesh System.
5. Click Apply/Save.
