Setting up your Linksys node by toob ISP

The Linksys SPNMX42TB and SPNMX56TB are Linksys Velop Intelligent Mesh™ routers provided by toob ISP in the United Kingdom.

If you ever need to reset your nodes to factory defaults, this article will guide you on how to set them up again.

Before you begin:

The default WiFi name is toob-xxxxxx, where xxxxxx is the last six alphanumeric characters of the MAC address. The default WiFi password is located on the product label.
Auto Configuration Server (ACS) support - This node supports Automatic Setup via ACS with toob ISP. Meaning that once the node is plugged into the toob modem and detects an internet connection, it will automatically configure itself as the parent node. Once the light turns solid blue, the node is set up and online.

DO NOT try to set up the node with the Linksys app while the node is going through the ACS setup, because the Linksys app will not detect the node. Wait until the node self-configures and the status light is solid blue.

Parent node - The Linksys SPNMX42TB or SPNMX56TB connected to your modem.
Child node - A child node is another node used to extend your WiFi network. The child node can be wireless or wired.

Directions:

1. Connect an ethernet cable from your toob modem's port to the internet port of the Linksys SPNMX42TB or SPNMX56TB.

2. Power ON your node and wait for the status light to turn solid purple, meaning it is ready for setup. The status light will then begin to flash white; this indicates that the node is going through an ACS setup. Wait until the status light is solid blue. This may take a few minutes. Once the status light is solid blue, the router is ready to use.

3. Connect your devices using the default WiFi name, which is toob-xxxxxx, and the password located on the product label of the node.

Your node is now set up. To manage your node with the Linksys app, proceed to the steps below.

Manage your node using the Linksys app

If you want to use the Linksys app to manage your settings, follow these instructions.

1. Download the Linksys app on your Android™ or iOS device and make sure to connect your mobile device to the WiFi name you just created.

2. On your device, launch the Linksys app and tap Manage Your Wi-Fi. For Android, tap Log in.

iOS	Android

3. Enter your Router Password and tap on Log in.

4. You can now manage your settings using the Linksys app.

To customize the router’s password, tap on the menu icon and tap on Network Administration. Select Change Router Password and Hint and customize your router’s password (case-sensitive). Once done, tap Save.

The router’s password is the administrative password that you can use when you are connected to your Linksys WiFi network. Make sure to write down your passwords.

Find out more:

Setting up a Linksys Mesh System using Bluetooth on your Mobile device