
HARDWARE INFORMATION
- Linksys LGS328PC
- Quick start guide
- Rack mounting kit and eight screws
- Four rubber feet
- Power cord (Internal power supply: AC power 100V – 240V AC at 50 Hz – 60 Hz, 4.0A)
SETUP AND INSTALLATION
The switch is a DHCP client by default. If the device fails to retrieve an IP address through DHCP, the default IP address is 192.168.1.251, and the factory default subnet mask is 255.255.255.0.
The Linksys LGS328PC can be rack-mounted.
To learn how to reset or reboot your switch, these are the things you need to do.
For instructions on how to back up and restore your switch’s current configuration, refer to this article.
FIRMWARE UPGRADE
Learn how to upgrade or check your switch’s firmware.
TROUBLESHOOTING
The PoE+ contains PoE subsystem information for monitoring the current power usage and assigns the total amount of power the switch can provide to all of its PoE+ ports.
A Virtual LAN (VLAN) is a group of ports that form a logical ethernet segment on a Layer 2 switch which provides better administration, security, and management of multicast traffic.
Voice VLAN provides Quality of Service (QoS) to Voice over Internet Protocol (VoIP), ensuring that the quality of the call does not deteriorate if the IP traffic is erratic or uneven.
Learn how to change the switch’s Access Timeout settings.
Learn about the router’s Security settings.
To configure the Access Control (ACL) settings of the switch, these are the things you need to do.
Learn how to configure the Monitor settings of the switch.
For instructions, refer to this article.
Find the instructions in this article.