The Linksys MX4300 (LN1301) is a router equipped with Tri-band Wi-Fi® 6 technology, designed to deliver unparalleled internet speeds of up to 4.2 Gbps. Enjoy a seamless Plug-n-Play setup, complemented by enhanced Parental Controls and a secure Guest network.
HARDWARE INFORMATION
- One Linksys MX4300
- One ethernet cable
- One power adapter with interchangeable plugs (12V, 3A)
- Quick start guide
- One gigabit internet port
- Three gigabit ethernet ports
- One power port
- One USB 3.0 port (Reserved)
These are as follows:
- Dimensions: 4.45 in x 4.45 in x 9.57 in
- Weight: 0.95 kg (2.15 lb)
SETUP AND INSTALLATION
You can install it using a Plug-n-Play setup.
Yes, on some occasions, such as when using a PPPoE connection, you can manually set up your router.
All you need is an active internet connection.
- The default IP address is 192.168.1.1.
- The default WiFi name is Linksysxxxxx, where xxxxx represents the last five characters of the router's serial number.
- The default Guest WiFi name is Linksysxxxxx-guest, where xxxxx represents the last five characters of the router's serial number. Guest Access is initially turned OFF both before and after setup. You'll need to enable this feature in the router's web interface.
- The default admin password is the same as the default WiFi password located at the bottom of the router.
FEATURES AND FUNCTIONS
Yes. The admin password can be changed in the router’s web interface.
It supports CloudFlare and Fast.com.
Yes, the time zone can be set in the Connectivity section of the web interface.
The Guest Access feature provides a convenient way to establish a distinct network for your guests, ensuring they cannot access your primary network or the devices connected to it.
ADVANCED SETTINGS
The Linksys MX4300 (LN1301) has automatic firmware updates. This is enabled by default, and upgrades happen whenever a new firmware version is released.
Updates can also be done manually.
No. WPS is not supported.
TROUBLESHOOTING
Plug-n-Play setup is supported when the router is connected directly to a modem for DHCP internet connections. In some situations, such as connecting the router to an existing network, the Plug-n-Play feature may not have been activated, yet the router is online. However, since the Plug-n-Play feature did not activate, the light did not change from purple to solid blue. To address the light situation, follow these steps you can follow to change the light to blue.
No. This model does not support Linksys Mesh; it is a standalone router only.
No. This router does not support the Linksys app.
No. Mesh technology is not supported.
Insert a small item into the reset button, such as a paperclip, then press and hold until the light on top of the router turns red, fades, and flashes bright red again to reset the router to its factory defaults (about 15 seconds).
