
The Linksys SPNMX56HF-UK supports the Wi-Fi® 6 (802.11ac) standard and offers massive simultaneous capacity for video, gaming, and high-speed data. It is easy to add to a modular system of nodes to give you flawless WiFi everywhere, and it easily replaces a standard router with mesh WiFi.
The Linksys SPNMX56HF-UK is for Hey!Broadband ISP subscribers in the UK only.
HARDWARE INFORMATION
Below are the parts of a node:
- Buttons and Switch
- Reset button
- Wi-Fi Protected Setup™ (WPS)
- One power switch (sliding)
- Ports
- Three 1 gigabit ethernet LAN ports
- One 2.5 gigabit internet port
- One power port
- Linksys Velop Intelligent Mesh™
- Wi-Fi 6 Dual-Band AX5400
- 2x4 Spatial Streams
- Band Steering
- Supports WPS
- Supports Dynamic Frequency Selection (DFS) - turned OFF by default
- Guest WiFi
- Parental Controls
- WiFi security
- Safe browsing feature
- Supports Dynamic Host Configuration Protocol (DHCP)
- Supports automatic setup via Automatic Configuration Server (ACS)
- Support TR069
- Supports parent and child modes
- The default IP address is 192.168.1.1. If the upstream device uses the same IP address, the node will automatically use a different LAN IP address to avoid any conflict.
- The default administrator password is the default admin password changes to the default WiFi password which is located on the product label.
- The default WiFi name is Hey!Broadband-xxxx where xxxx represents the last four alphanumeric characters of the node’s MAC address.
- Each node has a unique pre-assigned WiFi password located at the bottom of the node.
- The default Guest WiFi name is Hey!Broadband-xxxx-xxxxxx-guest where xxxxxx represents the last six alphanumeric characters of the node’s MAC address.
- The default WAN connection is DHCP.
- Dimensions: 3.385 in x 3.385 in x 7.3 in per node
- Weight: 0.50 kg (1.1 lb)
SETUP AND INSTALLATION
- WPA2™/WPA3™ Mixed Personal
- WPA3 Personal
- WPA2 Personal
- Open and Enhanced Open
- Open
FIRMWARE UPGRADE
TROUBLESHOOTING
To reset your node to its factory defaults, press and hold the reset button until the light on top of the node turns red, fades, and flashes bright red.
Make sure that a bright red flash, followed by three to four quick faded red pulses then another bright red flash occurs before you release the button.